1997 DODGE DAKOTA 2DR PICKUP
Security
Battery PNK/BLK + (+) OR RED IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION HARNESS
Starter01 BLU/YEL + (+) IGNITION HARNESS
AllDoorTrigger YEL (-) (-) HEADLIGHT SWITCH OR COURTESY LIGHT
TrunkTrigger N/A
FactoryAlarmDisarm BLK/ORG (-) 12 PIN BLK CONN BEHIND DR.DASH BELOW FUS
ParkingLights BLK/YEL (+) BEHIND FUSE BOX 74 PIN CONN BELOW FUSE B
Remote Start
Battery PNK/BLK + (+) OR RED IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION HARNESS
Ignition02 BLK/ORG + (+) IGNITION HARNESS (BLOWER)
Ignition03 +
Accessory01 BLK/WHT + (+) IGNITION HARNESS
Accessory02 +
Starter01 BLU/YEL + (+) IGNITION HARNESS
AntiTheftSystem NONE
KeySense LT.BLU (-) (-) STEERING COLUMN HARNESS
NeutralSafety BRN/WHT (-) DRIV SIDE OF TRANS.
Tach BLK/GRY (AC) OR GRY/BLK AT COIL PASS. SIDE OF ENGINE
SpeedSense WHT/ORG (AC) PCM,PASS.FENDER,WHT 32 PIN PLUG,PIN27
ParkingLights BLK/YEL (+) BEHIND FUSE BOX 74 PIN CONN BELOW FUSE B
BrakeLights WHT/TAN (+) (+) AT BRAKE SWITCH
ReverseLights VIO/BLK (+) (+) DRIV SIDE OF TRANS
Horn BLK/RED (-) AT FUSEBOX
Doorlocks / Window
PowerUnLock PNK/PPL (+) (+) POSITIVE TRIGGER
PowerLock LT.GRN/BLK(+) (+) OR ORG/VIO 14 PIN CONN RIGHT OF PARKBRAK
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:BRN/WHT
LeftRearWindow01 LF:WHT
RightRearWindow01 RF:PPL WHT
Convenience
HeadLights LT.GRN (+) (+) STEERING COLUMN
TrunkRelease N/A
Mobile Audio / Video
Battery PNK/BLK + (+) OR RED IGNITION SWITCH HARNESS
Accessory01 BLK/WHT + (+) IGNITION HARNESS
Ground N/A -
Illumination BLK/YEL (+) RADIO HARNESS
Dimmer ORG (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg BRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg DARK BLUE/RED
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/BLU
RearRightSpeakerPos DK.BLU/WHT
RearRightSpeakerNeg DK.BLU/ORG
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
